After conducting extensive testing on the 14-10 Pin (MQB) harness, it was discovered that in order to enable the high beams to function properly in the 10-pin halogen configuration, a jumper wire needed to be added to the J519 B connector on specific pins. These pins are listed PDF file along with the appropriate coding to be used.
It should be noted, however, that the current high beam channel is not powerful enough to operate the shutter on aftermarket lights. This is because the channel is only designed for an OEM shutter that uses the factory moldule in the headlight. Therefore, the SHUTTER10 and SHUTTER11 channels must be reconfigured to 8FL and 9FL, respectively. By doing so, the proper power supply will be provided to the shutter, ensuring that the high beams function correctly in the 10-pin halogen configuration.
If you have purchased an older variant and would like your high beams to function properly, please do not hesitate to contact us. A replacement will be sent out to you along with revised instructions and coding in the PDF file provided below.